Home Automated Living Forums - View Single Post

DaveGA · 10-25-2016, 08:12 PM

Hi All,

I just upgraded to 6.1.34 and noticed the Vera interface setting in the systems settings menu. I do have a Vera lite setup to run a few macros because I was having some issues with HAL being consistent with the Zwave (Schlage locks).

I see in the menu that there is an IP and Port setting in the configuration. Does this suggest that HAL can pass commands via TCP/IP to the Vera? If so, this is awesome.

Can you provide some detail? I looked in help and didn't see anything specific.

Thanks!

dave

10-25-2016, 08:12 PM	#1
DaveGA Member Join Date: Dec 2006 Location: Athens, Ga Posts: 52	Vera Interface Hi All, I just upgraded to 6.1.34 and noticed the Vera interface setting in the systems settings menu. I do have a Vera lite setup to run a few macros because I was having some issues with HAL being consistent with the Zwave (Schlage locks). I see in the menu that there is an IP and Port setting in the configuration. Does this suggest that HAL can pass commands via TCP/IP to the Vera? If so, this is awesome. Can you provide some detail? I looked in help and didn't see anything specific. Thanks! dave