DaveGA
10-25-2016, 08:12 PM
Hi All,
I just upgraded to 6.1.34 and noticed the Vera interface setting in the systems settings menu. I do have a Vera lite setup to run a few macros because I was having some issues with HAL being consistent with the Zwave (Schlage locks).
I see in the menu that there is an IP and Port setting in the configuration. Does this suggest that HAL can pass commands via TCP/IP to the Vera? If so, this is awesome.
Can you provide some detail? I looked in help and didn't see anything specific.
Thanks!
dave
I just upgraded to 6.1.34 and noticed the Vera interface setting in the systems settings menu. I do have a Vera lite setup to run a few macros because I was having some issues with HAL being consistent with the Zwave (Schlage locks).
I see in the menu that there is an IP and Port setting in the configuration. Does this suggest that HAL can pass commands via TCP/IP to the Vera? If so, this is awesome.
Can you provide some detail? I looked in help and didn't see anything specific.
Thanks!
dave